EECE 237 Embedded Systems Development
Homework 01, Fall 2016 Semester
Please type your answers on a document. You may save your document in the “.docx” format. When you are required to draw schematic diagrams or figures for digital circuits, you can hand-draw them on another sketch paper, take photos of the figures, and then insert them into your homework document.
Problem 1 (12 pts).Express equations of the following laws for AND and OR under the Boolean Logic. (1) Commutative Law; (2) Associate Law; (3) Distributive Law; (4) Identity of 0; (5) Identity of 1; (6) De Morgan’s Theorem.
Problem 2 (12 pts). In 16 words or less give definitions of the following terms: (a) Flip-flop; (b) HiZ; (c) Open collector; (d) Tristate; e) Register; (f) Bus.
Problem 3 (5 pts). How many binary bits does it take to represent 100,000,000,000?
Problem 4 (15 pts). In the C programming language (C99), an int8_t is 8 bits, an int16_t is 16-bits, and an int32_t is 32 bits. Assuming each is signed, give the range of each type of number.
Problem 5 (16 pts). Each row of the following table is to contain an equal value expressed in binary, hexadecimal, and decimal. Complete the missing values. Assume each value is 8 bits and the decimal numbers are signed. The first row illustrates the process.
Binary Hexadecimal Decimal
01011110 0x5E 94
0xD2
-67
11001011
0xE1
79
00101010
0xC7
-101
Problem 6 (15 pts). Modify the transistor level circuit in Figure 1.13 to implement a 3-input NAND. The output will be low if and only if all three inputs are high. I.e., design it with p-type and n-type MOS transistors.
Problem 7 (15 pts). Using P-type and N-type transistors, design an implementation of the exclusive OR gate.
Problem 8 (10 pts). Suppose we will design an interface using a resistor for an LED to connect to a microcontroller. Turning on an LED requires 2 mA at 2.0 V. A digital output low (VOL) on the microcontroller turns on the LED. That means we will utilize the negative logic. Hence, assume VOL = 0.3V from the microcontroller. Because of the direct connection to the microcontroller, we should use 3.3V for the interface of the microcontroller to power the LED (and not 5V). Calculate the value of the resistor that could make the LED be successfully turned on.
WRITE THIS ESSAY FOR ME
Tell us about your assignment and we will find the best writer for your paper.
Get Help Now!Introducing our Online Essay Writing Services Agency, where you can confidently place orders for a wide range of academic assignments. Our reputable homework writing company specializes in crafting essays, term papers, research papers, capstone projects, movie reviews, presentations, annotated bibliographies, reaction papers, research proposals, discussions, and various other assignments. Rest assured, our content is guaranteed to be 100% original, as every piece is meticulously written from scratch. Say goodbye to concerns about plagiarism and trust us to deliver authentic and high-quality work.
WRITE MY ESSAY NOW
